The thermostat has an adjustable inactive screen brightness. This allows the user to dim the screen to their desired
preference. (When actively using the thermostat display [i.e. – touching buttons / making changes] the thermostat
screen defaults to full brightness. This feature is not adjustable.)
Adjusting Screen Brightness:
Touch MENU. Touch the > arrow until BRIGHTNESS appears. Touch SELECT.
Use the +/- icons to increase or decrease the brightness (1-5). Press DONE when complete.
Recovery: (also referred to as Smart Recovery, Smart Start, and Adaptive Intelligent Recovery)
The thermostat has the option to begin your schedule setting changes early in order to reach your desired
temperature at the start of the schedule period. When active, the thermostat “learns” how long it takes to reach
setpoint within your home, and starts heating or cooling early. (ex. My home is 65° at night, but set to 70° at 7:00a.m.
Rather than waiting until 7:00a.m. to start warming up, Recovery begins Heating the home early [based on its
algorithm and learned behavior] and starts heating the home at 6:00a.m., reaching the 70° setting by 7:00a.m.) When
active, RECOVERY is displayed on the thermostat screen in the top right corner.
Turning Recovery On / Off:
Touch MENU. Touch the > arrow until RECOVERY appears. Touch SELECT.
Touch the < or > icons to enable or disable RECOVERY. Press DONE when complete
Clock:
When connected to Wi-Fi, the thermostat displays the local time based on the account creators Zip Code (as related
to Time Zone). When not connected to Wi-Fi, the clock can be configured on the thermostat display. 12hr or 24hr
time displays are optional, as is Daylight savings time (DST)
Clean Screen:
The Clean Screen feature disables the thermostat screen for 30 seconds. Wipe your thermostat with a clean, damp
cloth. After the timer runs out, the thermostat screen is reactivated and returns to the main display.
Temp Scale:
You can adjust the temperature display settings at any time. Display temperatures are available in Fahrenheit or
Celsius
Changeover:
The changeover feature (also referred to as Auto changeover) allows your thermostat to automatically switch from
heating to cooling, or vice versa, depending on the temperature in your home. Resideo requires that a 1.5 degree
difference be enforced between the heating and cooling setpoints when this feature is enabledto prevent short-
cycling (repeatedly turning your system on/off too quickly) You may notice that your home naturally warms or cools
up to 1.5 degrees past your setpoint before the appropriate heating or cooling system begins operation. This is
normal.
Reset:
The thermostat has 4 reset options: Factory, Schedule, Wi-Fi, and Homekit.
Factory Reset: clears all of the thermostats programming and resets it to factory defaults
*Prior to performing a Factory Reset, we recommend recording your current ISU configuration (see Setup and
Configuration)
Schedule reset: clears the schedule and resets it to the daily default schedule listed below:
Wake 6:00a.m. Cool 78 Heat 70
Away 8:00a.m. Cool 85 Heat 62
To Next Page
Loading...
Need help?
General
