7 63-4038—7
1. For a wall installation, hold subbase or wallplate in
position and mark holes for the anchors. See Fig. 4. Wall
anchors must be obtained locally. Be careful that the wires do
not fall back into the wall opening. Set aside subbase or
wallplate.
2. Drill four 3/16 in. (4.8 mm) holes and gently tap
anchors into the holes until flush with the wall.
3. Pull wires through the cable opening. See Fig. 11.
Fig. 10—Setting subbase DIP switches.
M4410
BA3A2W2Y2TA1 T
Y1
GRCRH
CA1
CA2 CA3 CA4 CA5
LED1
LED2 COM
BA3A2W2Y2TA1 T
Y1
GRCRH
CA1
CA2 CA3 CA4 CA5
LED1
LED2 COM
MOUNTING TO HORIZONTAL 2 X 4 JUNCTION BOX
MACHINE
SCREWS
MOUNTING TO WALL BOARD
OR
SHEET METAL
SCREWS
Fig. 11—Installing subbase on outlet box or on wall.
BA3A2W2Y2TA1 T
Y1
GRCRH
CA1
CA2 CA3 CA4 CA5
LED1
LED2 COM
M4401
1
234
5
1
1
CONFIGURATION OF ILLUSTRATED SWITCH IS:
1 – ON
2 – OFF
3 – OFF
4 – ON
5 – ON
O
N
T7200/T7300/Q7300
INSTALLATION
To Next Page
Loading...
