VISIONPRO® 8000 SMART THERMOSTAT
71 33-00096—04
mostat will indicate whether this meets or may not
meet the ASHRAE 62.2 Standard or the Percent On
Time setting. See Fig. 168.
NOTE: ISU 1014 Lockout Ventilation on Humidifi-
cation or Dehumidification Calls is not an
option when you select ASHRAE is Priority at
ISU 1012.
Fig. 168.
11. Select whether to Ventilate on High Indoor Humidity.
See “Ventilate on High Indoor Humidity (ISU 1016)”
on page 68 for more information. See Fig. 169.
Fig. 169.
Control Ventilation Level
1. Touch MENU, and select Ventilation.
Fig. 170.
Fig. 171.
2. Select Mode, Temporary Boost, or Lockout, then
select appropriate options.
Fig. 172.
3. Touch Done to save your settings. Touch Cancel to
ignore changes.
Fig. 173.
Ventilation Options
Mode:
Auto: Ventilation runs as programmed by the installer.
Off: Ventilation remains off unless turned on using the
timer.
On: Ventilation is always on.
Fig. 174.
Temporary Boost: Touch or to select how long to run
ventilation temporarily. To turn it off, set it to zero.
Fig. 175.
Lockout: Touch or to select Yes or No, then touch Next.
Select Yes to prevent ventilation from running during the
Sleep or Unoccupied (commercial) program periods or
when outdoor conditions exceed values set by the installer.
MCR34132
Ventilation
Equipment Status
MCR34133
Mode
Temporary Boost
MCR34135
Ventilation Mode
Off Auto On
MCR34136
Run Ventilation For
60 minutes
To Next Page
Loading...
