EasyManuals Logo

Honeywell TUXWIFIW Installation And Setup Guide

Honeywell TUXWIFIW
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
First Time Setup (cont'd)
15
Set the “Start DST” time and then the “End DST” time by selecting the appropriate Month, Weekend
and Hour that DST starts and ends.
When done, press Apply .
After each selection the window closes automatically and the selection is displayed.
Select a 12-hour or 24-hour format for your time display by pressing the circle to the left of the
12 Hour
display.
When done, a confirmation screen appears.
Yes
saves the time changes in your security system.
No
saves the changes to the Tuxedo only.
NOTE:
A
Yes
response is recommended.
Power Mode Setup
Power Mode allows you to reduce power consumption in the event of a system trouble such as AC Loss
or Panel Low Battery.
Press the Setup , System setup
and Power Mode Setup icons and enter your authorized
code, if required.
Select Power Save Mode to enable; then choose Turn-off Network, or Override Display Settings.
Press Apply to save settings.
NOTE: When Override Display Settings is selected, Display settings are overwritten and Tuxedo
operates in low power mode:
- Brightness/Volume controls decrease to minimum levels.
- Return To Homepage After time resets to 30 seconds.
- Auto SlideShow After time reverts to Never.
- When AC power is restored, the original Display settings resume.
Remote Access Setup
Tuxedo’s remote access option offers built-in web hosting capability to access your system via any web
enabled device. Tuxedo can connect to a network router via Ethernet cable (LAN network) or via WiFi
depending on the installation preference. Refer to the Remote Access section for details on using
Tuxedo remotely.
From the "Home" screen, press the Setup and IP Setup
icons.
Select a type of network connection
:
LAN ON or WIFI ON
and press Save
.
Go to that section below for further information.
Setup a LAN Connection
Press the LAN ON button. A pop-up window displays:
This will switch off WLAN Network, do you want to continue? Yes or No
Connect an Ethernet cable between the router and the keypad; the IP address and default gateway
address of the router is displayed.

Table of Contents

Other manuals for Honeywell TUXWIFIW

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell TUXWIFIW and is the answer not in the manual?

Honeywell TUXWIFIW Specifications

General IconGeneral
BrandHoneywell
ModelTUXWIFIW
CategorySecurity System
LanguageEnglish

Related product manuals