To Next Page

To Previous Page

Z-Wave Setup (cont’d)

1. Press Automation  Scene Setup  Add .

2. Press Scene Name; enter a “name” and press OK.

3. Assign the “Condition,” “Trigger,” and “Action” you choose for this Scene.

After each selection press Save!

Scene Options

Set the TIME: In the Trigger/Condition box, press Add. Press the TIME button > Set the

occurrence.

If ONCE > Enter Date; if REPEATED > choose days of the week; if BY CLOCK > press on the

“Hour/Minutes” displayed and enter the Start and End Time > press on AM/PM; if SUNRISE or

SUNSET > press the option. Check the Critical Event check box to record and store a maximum of

two events even when the SD card is not available. If more than 2 critical events occur, then the

older one is replaced by the latest event.

NOTES:

• The Sunrise/Sunset feature is dependent on the “Region” selected in the “Weather Forecast”

section and requires internet access for accuracy.

• BY CLOCK allows you to activate the scene for a specified period of time.

Set the Security Mode: In the Trigger/Condition/Action box, press Add. Press the SECURITY

button and select from DISARM, AWAY, STAY, NIGHT, AWAY SECURED or ALARM. Enter

User Code, if required.

NOTES:

• AWAY triggers upon arming away.

• AWAY SECURED triggers when exit delay has expired.

Set the Thermostat: In the Trigger/Condition/Action box, press Add. Press the THERMOSTAT

button and select a Thermostat Device from the drop-down menu. Use the ABOVE and BELOW

buttons to increase/decrease the temperature or press the Temperature Value box and enter 2

digits for the desired temperature.

NOTES:

• Test thermostats first to ensure proper function in the “Scene.”

• Some thermostats do not update temperature status automatically (i.e., Wayne Dalton).

Set the Door Locks: In the Trigger/Condition/Action box, press Add. Press the DOOR button and

select a Door Device from the drop-down menu. Select LOCKED or UNLOCKED or CODE

UNLOCKED.

NOTES:

• Motorized door lock bolts physically lock and unlock when activated, but if the door lock

installed is a non-motorized type, activation allows the door to be manually unlocked without a

key. See “Compatible Devices” section later in this document.

• When using a Kwikset Smartcode electronic deadbolt door lock (in a Scene that is programmed

to trigger when unlocked) the Scene does not trigger if using a key; enter a user code.

Honeywell TUXWIFIW Installation And Setup Guide

Other manuals for Honeywell TUXWIFIW