Honeywell Voyager 1450g Series - Codabar Concatenation

7 - 3
Codabar Concatenation
Codabar supports symbol concatenation. When you enable concatenation, the scanner looks for a Codabar symbol having
a “D” start character, adjacent to a symbol having a “D” stop character. In this case the two messages are concatenated
into one with the “D” characters omitted.
Select Require to prevent the scanner from decoding a single “D” Codabar symbol without its companion. This selection
has no effect on Codabar symbols without Stop/Start D characters.
Codabar Message Length
Scan the bar codes below to change the message length. Refer to Message Length Description (page 7-1) for additional
information. Minimum and Maximum lengths = 2-60. Minimum Default = 4, Maximum Default = 60.
Validate Modulo 16, but
Don’t Transmit
Validate Modulo 16
and Transmit
A1234D D5 6 7 8 A
On
* Off
Require
Minimum Message Length
Maximum Message Length