Honeywell Voyager 1450g Series - Page 162

10 - 8
Cordless System Operation
Note: This section applies only to cordless systems. It does not apply to corded scanners.
Base Power Communication
Indicator
*On :*:BASRED1 3-5
Off :*:BASRED0 3-5
Reset Scanner Reset Scanner RESET_ 3-6
Scanning While in Base Cradle Scanning in Cradle Off BT_SIC0 3-6
*Scanning in Cradle On BT_SIC1 3-6
Shut Down Scanner in Cradle BT_SIC2 3-6
Base Charging Modes Base Charge Off BASCHG0 3-7
*External or Interface Cable Power BASCHG1 3-7
External Power Only BASCHG2 3-7
Paging Mode *On BEPPGE1 3-7
Off BEPPGE0 3-7
Paging Pitch Low (*1000 Hz) BEPPFQ1000 3-7
Medium (3250 Hz) BEPPFQ3250 3-8
High (4200) BEPPFQ4200 3-8
Beeper Pitch - Base Error *Razz (250) (min 200Hz) BASFQ2250 3-8
Medium (3250) BASFQ23250 3-8
High (4200) (max 9000Hz) BASFQ24200 3-8
Number of Beeps - Base Error *1 BASERR3 3-8
Range 1 - 9 BASERR# 3-8
Scanner Report Scanner Report RPTSCN 3-8
Scanner Address Scanner Address BT_LDA 3-9
Base Address Base Address :*:BASLDA 3-9
Scanner Modes Charge Only Mode :*:BASLNK0 3-9
*Charge and Link Mode :*:BASLNK1 3-9
Locked Link Mode BASCON0,DNG1 3-10
*Open Link Mode BASCON1,DNG1 3-10
Unlink Scanner BT_RMV 3-10
Override Locked Scanner BT_RPL1 3-10
Out-of-Range Alarm Base Alarm Duration (Range 1 - 3000 sec
(*0))
BASORD 3-11
Scanner Alarm Duration (Range 1 - 3000
sec (*0))
BT_ORD 3-11
Alarm Sound Type Base Alarm Type BASORW 3-11
Scanner Alarm Type BT_ORW 3-11
Scanner Power Time-Out Timer Timer (0-7200 seconds) BT_LPT0 3-12
200 Seconds BT_LPT200 3-12
400 Seconds BT_LPT400 3-12
900 Seconds BT_LPT900 3-12
3600 Seconds BT_LPT3600 3-12
7200 Seconds BT_LPT7200 3-12
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page