Honeywell WICKER PARK - Light Kit Installation

9-pin Connector
Fitter Plate
Screw
Light Ring
Halogen Bulb
Light
Housing
Fig. 20
20. Unscrew and remove the light rings from the
bottom of the three light housings. Then, install
the halogen bulbs and re-install the light rings
(Fig. 20).
21. Attach the pull chain extensions to fan and light
pull chains. The fan pull chain extends from the
side of the light kit and the light pull chain extends
from the center of the light kit. (Fig. 21)
Fig. 21
Light
Pull
Chain
Fan
Pull Chain
Pull Chain
Extension
Fan Pull Chain
Extension
Light Pull Chain
Extension
Fitter Plate Screw
13
LIGHT KIT INSTALLATION
Fig. 19
19. Remove the pre-assembled tter plate screws from
the tter plate. Connect the 9-pin connector from
the fan to the 9-pin connector to the light kit.
Then, lift the light kit over the tter plate and
secure the light kit to the tter plate using the three
previously removed tter plate screws (Fig. 19).