15
2
Remove the brushroll
belt and brushroll from
the holding channels
inside of the power
head nozzle.
1
Lay the unit at to access
the power head nozzle.
Remove the 7 screws to take
off the baseplate from the
power head.
3
Rotate both plastic black
endcaps at the ends of the
brushroll to show a single
notch “SPECIAL” position.
Insert back into the holding
channels of the power head
nozzle.
Maintenance - Removing the brushroll and belt
SPECIAL
WARNING:
TO REDUCE THE RISK OF PERSONAL INJURY, UNPLUG BEFORE CLEANING OR
SERVICING. DO NOT USE VACUUM WITHOUT INNER FILTRATION BAG IN PLACE.
4
When rotating the black
endcaps on the brushroll,
make sure both endcap
settings are the same and
faceup when you insert
the brushroll.
REMOVING THE BRUSHROLL AND BELT
To Next Page
Loading...
