HOS Orbot - Technical Details ORBOT Sprayborg; Usage; General Advices; Unpacking and Initial Operation

2
TEcHNIcAL DETAILs ORbOT sPRAYbORG
Motor: 1HP, 100-240V/50-60Hz, 6 amps (50Hz)/11amp (60Hz)
RPM: 1725 (60Hz)/1400 (50Hz)
Base diameter: 17“/43 cm
Orbital diameter: 3/8” (9.5 mm)
Weight: 82 Lbs./37 kg (Orbot)/102 Lbs./46 kg (Orbot SprayBorg)
Height: 48” (122 cm)
Compact size for transport and storage: 30” (76 cm)
Wheels: 10”/25 cm Diameter, resistant to chemicals
UsAGE
NOTE: The Orbot SprayBorg is not suitable for use or storage in wet conditions.
General Advices
 • Everyonewhousesthemachineshouldhavereadtheseinstructionscarefully.Allpersonswho
operate the machine or stay close should take appropriate safety precautions.
 • UsetheORBOTSprayBorgonlyforintendedapplication.
 • Donotuseaccessorieswhicharenotdesignedandrecommendedbythemanufacturer.
 • Donotusethemachineiftheswitchdoesnotturnitonandoff.Anypowertoolthatcannotbe
controlled with the switch is dangerous and must be repaired
 • Disconnecttheplugfromthepowersourcebeforemakinganyadjustments,changingaccessories,
or storing. Such preventive safety measures reduce the risk of starting the machine accidentally.
 • Donotuseadamagedaccessory.Beforeeachuseinspecttheaccessorysuchasthepaddriver
forcracks,tearsorexcesswear.Ifthemachineoraccessoryisdropped,inspectfordamageto
install an undamaged accessory.
 • Repairthedamagedmachinebeforethenextapplication.
Unpacking and Initial Operation
 • Opentheshippingboxonbothsides,removethepackagingmaterialandrollthemachineoutof
thebox.
 • Putthehandleinanuprightposition(Fig.1,2).
Fig. 1 Fig. 2