HOS Orbot - Page 6

To Next Page

To Previous Page

 • Liftthestar-shapedscrewknobsupandoverthetoplatchbracketandturnclockwisetolock

properly (Fig. 3, 4)

Fig. 3 Fig. 4

 • Fillthewaterbottlewithwater.Youcanaddacleaningsolutionofyourchoiceintheprescribed

mixingratio.

 • Placethelledwaterbottleclosetothemachineontheoor.Insertthelterintothewatertank

(Fig.5).Makesurethatthelterreachesthebottomofthebottle.

Fig. 5

 • Turnthewater bottlecounter-clockwisewhileyouxthecontainercapwithyourotherhand.Seal

properly (Fig. 6).

Fig. 6

NOTE: Never seal the container by turning the cap itself! This can lead to distortion and damage

of the hoses.

 • Toinsertandremovethewaterbottleinandoutofthecageholder,insertorremoveatanangleon

the top hoop of the cage holder. When inserting the bottle, push the container down until it rests

rmly(Fig.7,8,9).