HOS Orbot - Stromversorgung; Power Supply; Process of Cleaning; End of the Application

6
Fig. 19
WARNING: Make sure a suitable pad or brush is mounted before starting the machine. The
immediate contact of the floor and driver plate without a pad can lead to serious damage of the
floor and/or the machine.
Power Supply
 • USA/Canada-Plugthepowercordintoa110voltoutletwithasupplyofatleast11amps.
 • Europe-Plugthepowercordintoa230voltoutletwithasupplyofatleast6amps.
 • Australia-Plugthepowercordintoa240voltoutletwithasupplyofatleast5amps.
 • Ifyouareinneedofalongerpowercord,makesureitisaminimumof12/3gaugefor100-110Volt
circuitsor6mm²extensioncordfor230-240Voltcircuits.
Process of Cleaning
 • ForeffectiveoorcleaningwiththeORBOTSprayBorg,movethemachineforwardandbackwards.
Werecommendyoutowettheoorasyoumovethemachineforward,releasingthespraybutton
when you move the machine backwards.
 • Toincreasethepressureandcleaningeffectoncertainoorsliketileandgrout,youcanliftthe
machine frame up, raising the wheels off the ground. When lifting the wheels off the ground the full
weight of the machine lies on the machine base.
 • WARNING:Makesurethesurfacetobecleanedisnotdamagedbytheincreaseinpressure.Omit
this measure on very sensitive floors.
End of the Application
 • Turnoffthemachinebyputtingtheredon/offswitchto“O”.
 • Ifyouusedacleaningsolution,rinsethepumpsystemwithclearwater.Installabottlelledwith
clearwaterinthecageholder(toexchangethewaterbottle,seepg.9).Ifyoudonothaveanopen
areatosprayandrinsethepump,werecommendplacingaSuperZorbpadontheoorinfrontof
the spray jets and directly spray onto it. Press and hold down the spray button until the water is
totally clear.
WARNING: Omitting this rinsing process can lead to internal hose, filter, and/or pump damage.
 • Tostorethebaseintheuprightposition,pressdownthehandleframewiththerighthandandlift
up the base with the left hand by grabbing the base handle (Fig. 20, 21).