HOTA D6 Pro - Page 22

1
4
2
5
3
6
Working Parameters Display
Operation and Setup
Operation Time
Capacity Charged
Battery
Type- string
Number Current
Task Status
Present
Current
Current
Total Battery
Voltage
Cell Voltage
Device Name Completion
Percentage
Current Channel
19
D6 Pro AC/DC Dual Channel Smart Charger
Balancing
Balancing Status Simple Operation
1. Connect power supply to the AC or DC port of the charger, wait for the system to
complete the self-checking. connect the battery to the charger in the standby interface;
2. After select the corresponding channel，short press the speed shuttle key to pop up
the“Task Settings”menu, set the task to“Balance”, adjust the task parameters, and
short press the speed shuttle key to start the task;
Scroll the speed shuttle key during operation can switch the display information in the lower half of the screen，
which are cell voltage and run data，the cell voltage and internal resistance can only be displayed in the mode
of balance charging.
3. When the balance task is executing, short press the speed shuttle key to pop up the
“Adjust Task”menu，will adjust the balance current，long press the CH key can stop
the current task；
4. Enjoy.