HotSpring Landmark - Hot Spring Water Treatment Guide

Sodium Dichlor (chlorine) is the only recommended sanitizer that will work in conjunction with all of the other products in this system.
FreshWater
®
III high output ozone system uses corona discharge technology to produce a high concentration of ozone which is injected into the
spa water.
Monopersulfate (MPS) is an oxidizing chemical used to prevent the buildup of contaminants, maximize sanitizer efficiency, minimize combined
chlorine and improve water clarity.
FreshWater
Ag
+
®
Silver Ion Purifier introduces silver ions into the spa water, inhibiting bacteria growth. When combined with MPS or chlorine,
oxidizes particulates in the spa water.
It is important to follow the recommended application and maintenance programs outlined for each product’s use.
If the spa is being used over an extended period of time, such as a whole afternoon or evening, additional sanitizer will be needed.
A weekly “shock treatment” is required.
The shock treatment quickly destroys any remaining contaminants while revitalizing the silver ion cartridge, allowing the silver ions to continue to
be released into the water. Without this weekly shock treatment, the silver ion cartridge may stop releasing silver ions into the water.
To weekly “shock treat” your spa you may use either MPS or sodium dichlor. It will require much less sodium dichlor to administer the shock
treatment than MPS (1 teaspoon of sodium dichlor has oxidizing capabilities comparable to 2 tablespoons of MPS). Sodium dichlor may be a
more appropriate weekly shock for those users that experience heavy bather load conditions.
IMPORTANT NOTE: MPS is an oxidizer, not a sanitizer.
Water Quality and Maintenance Page 46
HOT SPRING
®
WATER TREATMENT GUIDE
At spa
startup
or refill
Follow Start-Up and Refill Procedures section
NOTE: Use the FreshStart
™
10,000
pre-filter when filling the
spa to remove unwanted contaminants.
Prior to
each use
(Test before adding
any chemicals; do not
add any chemicals if
proper or higher levels
are found.)
Add one (1) tablespoon of monopersulfate
(MPS)* per 250 gallons
Landmark
®
(Model S) 2 tablespoons
Grandee
®
(Model G) 2 tablespoons
Vanguard
™
(Model V) 1-1/2 tablespoons
Sovereign
®
(Model I) 1-1/2 tablespoons
Prodigy
®
(Model H) 1-1/4 tablespoons
Jetsetter
®
(Model J) 1 tablespoon
Add one-half (1/2) teaspoon of chlorine per
250 gallons
Landmark
®
(Model S) 1 teaspoon
Grandee
®
(Model G) 1 teaspoon
Vanguard
™
(Model V) 3/4 teaspoon
Sovereign
®
(Model I) 3/4 teaspoon
Prodigy
®
(Model H) 2/3 teaspoon
Jetsetter
®
(Model J) 1/2 teaspoon
Once a
week
Add three (3) tablespoons of monopersulfate
(MPS)* per 250 gallons
Landmark
®
(Model S) 6 tablespoons
Grandee
®
(Model G) 6 tablespoons
Vanguard
™
(Model V) 4-1/2 tablespoons
Sovereign
®
(Model I) 4-1/2 tablespoons
Prodigy
®
(Model H) 4 tablespoons
Jetsetter
®
(Model J) 2-1/2 tablespoons
Add one and one half (1-1/2) teaspoons of
chlorine per 250 gallons
Landmark
®
(Model S) 3 teaspoons
Grandee
®
(Model G) 3 teaspoons
Vanguard
™
(Model V) 2-1/4 teaspoons
Sovereign
®
(Model I) 2-1/4 teaspoons
Prodigy
®
(Model H) 2 teaspoons
Jetsetter
®
(Model J) 1-1/2 teaspoons
Every four
months
Drain and refill your spa.
Replace the FreshWater
Ag
+
®
silver ion purifier
NOTE: Use the FreshStart
™
10,000
pre-filter when filling
the spa to remove unwanted contaminants.
As needed,
if water is
hazy,
cloudy or
has an odor
Add one and one half (1-1/2) teaspoons of chlorine
per 250 gallons
Landmark
®
(Model S) 3 teaspoons
Grandee
®
(Model G) 3 teaspoons
Vanguard
™
(Model V) 2-1/4 teaspoons
Sovereign
®
(Model I) 2-1/4 teaspoons
Prodigy
®
(Model H) 2 teaspoons
Jetsetter
®
(Model J) 1-1/2 teaspoons
*MPS is an oxidizer, not a sanitizer.
OR
OR