Page 16
Operating Instructions
panel and will remain displayed for as long as the summer timer is on.
The circulation pump and heater will automatically shut down for the
same eight hours every day until the summer timer is deactivated. It is
recommended to activate the summer timer in the morning so that the
spa is off during the hottest part of the day and so that the circulation
pump will start up again in the evening when you are ready to enjoy the
spa again.
IMPORTANT: The Summer timer will not lower the spa’s water
temperature below the ambient air temperature. Ambient conditions,
including humidity, wind and shading will affect your spa water
temperature.
To activate the Summer timer, simply follow these steps:
• Press the OPTIONS Hard button on the Control panel.
• Press the soft button next to Set up.
• Press the soft button next to Summer
timer to activate. The Summer
timer icon (on the Home Screen) will
display when activated.
IMPORTANT: If water temperature falls
below 26.7°C (80°F) the summer timer
will automatically be disabled.
• The Summer timer should be
deactivated when cooler temperatures return. To do this, simply repeat
last 3 steps. The Summer timer icon will turn off.
LANGUAGE
The Control panel screen can be viewed in five different languages.
The languages are English, French, German, Dutch, and Spanish. To
change languages:
• Press the OPTIONS hard button on the Control panel.
• Press the soft button next to Set-Up.
• Press the soft button next to
Language until the desired language
is visible.
IMPORTANT: Should you accidently
change the language screen into a
language you don't know, simply
repeat the previous steps where
Set-up is in the top right corner and
Language is in the lower right corner.
BRIGHTNESS
If you would like to change the brightness of the Control panel screen:
• Press the OPTIONS hard button on the Control panel.
• Press the soft button next to Set-up.
• Press the soft button next to Brightness to lower the brightness
from 7 down to 1.
IMPORTANT: Pressing the Brightness soft button at number 1 will
increase the screen brightness back to 7.
ACE WATER CARE (OPTIONAL)
If your spa has the ACE WATER CARE system installed you can
navigate to the ACE screen as follows:
• Press the OPTIONS hard button on
the Control panel.
• Press the soft button next to Water
Care.
(see ACE owner's manual for more
information).
• This Source screen illustrates the
current audio source the spa is using.
• Press the soft button next to ▲ or ▼ to change the desired source:
iPod
®
, TV, AUX or Bluetooth
®
.
AUDIO (OPTIONAL)
If a wireless audio sound system
is installed, both the Home screen
and the Options screen will display
the Audio function.
To enter the Audio menu screen:
• Press the soft button next to
Audio.
TO TURN AUDIO
SYSTEM ON/OFF
• Press the soft button next to Audio OFF to turn the Sound System
on or off next to Audio ON. Audio must be ON to advance the audio
screens.
TO PAIR BLUETOOTH
1. Press the Function:SET soft button 3 times to advance to the
Enter Setup screen. Press the Enter Setup soft button to advance
to the Setup Source screen. Bluetooth should be selected.
2. Press SETUP Source soft button 6 times from SETUP Source
screen to advance to the PAIR
screen.
On your device, find My Spa BTXR.
If you do not see this, another device
may already be connected (see To
Disconnect Bluetooth on following
page).
3. Press PAIR soft button followed by
pressing "connect" next to My Spa
BTXR on your device to pair.
After pairing, you will be ready to use your Bluetooth device. Only one
paired Bluetooth device will work at a time.
TO ADJUST VOLUME
• Press the soft button next to ▲ or
▼ to change the volume level.
• Press the Function:SET soft button
to advance to the Play/Pause
function screen.
To Next Page
Loading...
Need help?
General