STANDARDS AND CODES
SERVICE MANUAL 7
REVISION 04/19, SW: 3.51
STANDARDS
AND CODES
U.S. and Canadian installations
The installation must conform with local codes, or in the absence of local codes, with
the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the Natural Gas and Propane
Installation/service Code, CSA B149.1, as applicable.
Installation/service must conform with local codes, or in the absence of local codes, with
the National Electrical Code, ANSI/NFPA 70-Latest Edition and/or Canadian National
Electric Code C22.1 as applicable.
Appliance is to be installed with back flow prevention in accordance with applicable
federal, province and local codes.
Australia and general export installations
Installation must conform with Local and National installation standards. Local
installation codes and/or requirements may vary. If you have any questions regarding
the proper installation, service, repair and/or operation of your HOUNÖ oven, please
contact your local distributor. If you do not have a local distributor, please call the
HOUNÖ Oven Company at +45 87 11 47 11.
To Next Page
Loading...
