CHARGING YOUR SUPERFLY
CHARGING THE DEVICE
Ensure that the charging port is clean and dry.
Make sure that there is no dust, debris or dirt inside the port.
Plug the charger into a grounded wall outlet. The charging
indicator light ON THE CHARGER will flash green.
Connect the cable with the power supply (100-240V; 50/60 Hz).
Align and connect the 3-pin charging cable into the charging
port of the Superfly. DO NOT FORCE OR BEND THE CHARGING
CABLE INTO THE CHARGING PORT, AS IT MAY CAUSE THE PRONGS
TO BEND OR BREAK.
Once attached to the board, the charging indicator light ON THE
CHARGER should be flashing in GREEN, indicating that your device is
now being charged.
When the GREEN light on your charger stops fiashing, then your
Hoverboard is fully charged. A full charge may take up to 5 hours,
While charging you will see a GREEN light.
A full charge may take up to 5 hours. Only charging with
powered-on scooter, you will see yellow flashing light on the
scooter, which both indicates charging. Do not charge for more
than 6 hours.
After fully charging your Superfly, UnplCJg the charger from your
device and from the power outlet.
BATTERY CARE / MAINTENANCE
BATTERY SPECIFICATIONS
Battery Type: Rechargeable lithium-ion battery
Charge Time: Up to 5 hours
Voltage: 25.2 V
Initial Capacity: 4 .0Ah
BATTERY MAINTENANCE
The lithium-ion battery is built into the device. Do not disassemble
the device to remove the battery or attempt to separate it from the
device.
When charging the device, please use the enclosed 3-pin
charging cable or otherwise ensure that the battery charging
conditions are met.
Do not connect or attach the device or the battery to a power
supply plug or directly to a car's cigarette lighter.
20
To Next Page
Loading...
