Power connector cable
Description Spare part number
Power connector cable (includes bracket) 730900-001
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 33).
5. Remove the service door (see
Service door on page 34).
Remove the power connector cable:
1. Remove the two Phillips PM2.0×5.5 screws (1) and the Phillips PM2.5×10.5 screw (2) that
secure the display assembly right hinge to the computer.
2. Open the display assembly right hinge (3) as far as it will open.
3. Disconnect the power connector cable (4) from the system board.
4. Release the power connector cable from the retention clips (5) and routing channel built into the
bottom cover.
52 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
Need help?
General
