HP 1810-8 - Connect the Switch to a Power Source

2-13
Installing the Switch
Installation Procedure
4. Connect the Switch to a Power Source
1.) For the 1810-24 and 1810-24G Switch, plug the included power cord into
the switch’s power socket and into a nearby AC power source.
For the 1810-8 and 1810-8G Switch, plug the AC/DC adapter’s power cord
into the switch, and then plug the AC/DC power adapter into a nearby AC
power source.
2.) Re-check the LEDs during self test. See “Self Test LED Behavior” on
page 2-7.
3. For the 1810-8 and 1810-8G Switch, use the included cable tie to secure
the power cord to the switch.