HP StorageWorks Disk System 212026
View Disk Status
HP-UX and MPE/iX utilities provide descriptive and diagnostic information about
disks, including disk type, firmware revision, and errors. On HP-UX and MPE/iX 6.5
or later, the disk utility is Support Tools Manager (STM). For all other operating
systems, consult the appropriate system administration manual for disk module status
checking procedures.
STM Disk Information: HP-UX
STM displays the last-generated Information Log for a selected disk. Start STM and
run the Information tool as follows.
1 Log on the system.
2 At the system prompt, type xstm&. STM starts and displays a graphic of the
devices on the system.
3 Select the desired disk.
4 Select Information from the Tools menu.
5 To generate a current log, select Run. The log will be displayed as soon as it is
generated
6 To view a log without updating the contents, select Information Log.
7 Select Done when you have finished viewing the information.
8 To quit STM, type exit.
Figure 15 shows a sample Information Log.
To Next Page
Loading...
