HP 2120 - STM Disk Information: Mpe;IX 6.5 or Later

HP StorageWorks Disk System 212028
STM Disk Information: MPE/iX 6.5 or Later
STM displays the last-generated Information Log for a selected disk. Start STM and
run the Information tool as follows.
1 Log on the system.
2 At the system prompt (:), type vsclose <physical volume number>. This removes
the disk from use.
3 At the system prompt (:), type cstm. STM starts.
4 At the cstm prompt, type map. STM displays a list of all the disks installed on the
system.
5 Select the desired disk by typing select device <number>; for example, select
device 15.
6 Type information. STM updates the system map.
7 To display the information log, type infolog. A sample information log is shown
in Figure 16.