20
brightness scale as needed.
Check Video Cable is
displayed on screen.
Monitor video cable is disconnected. Connect the appropriate
video signal cable between
the computer and monitor. Be
sure that the computer power
is off while connecting the
video cable.
“Input Signal Out of
Range” is displayed on
screen.
Video resolution, refresh rate, or both, are set
higher than the monitor supports.
Change the settings to a
supported setting.
The monitor does not
enter into a low-power
sleep state.
The monitor's power saving control is disabled. Open the OSD menu and
select Power, select Auto-
Sleep Mode, and then set
auto-sleep to On.
“OSD Lockout” is
displayed
The monitor’s OSD lockout function is enabled. Press and hold the Left
button for 10 seconds to
disable the OSD Lockout
function.
“Power Button
Lockout” is displayed.
The monitor's Power Button Lockout feature is
enabled.
Press and hold the Power
button for 10 seconds to
unlock the power button
function.
Monitor has trouble
waking from Sleep
mode
DisplayPort or USB Type-C
inputs: Set the DisplayPort
hot-plug detection to Always
Active.
Power mode monitors: Set
the hot-plug detection to
Always Active to switch the
monitor to Performance
mode.
Slow performance
from USB
The monitor has a two-lane
default form USB-C. On
selected products, you can
press the Joypad button to
open the OSD menu,
navigate to the USB type-C
configuration, and then select
USB-C Video +USB 3.0 for
data transfer prioritization
Lower refresh rate or
color bits
Select USB-C Video +USB
2.0 for refresh rate/color bits
prioritization
LAN connection drop Check if the LAN driver
version on the host PC is up
to date.
To Next Page
Loading...
