HP 3600 v2 Series

To Next Page

To Previous Page

...............................................................................

.....................................Done!

System is starting...

Board checking.......................LSJ252TPA

SDRAM fast selftest........................OK!

Flash fast selftest........................OK!

CPLD selftest..............................OK!

Switch chip selftest.......................OK!

PHY selftest...............................OK!

Please check leds....................FINISHED!

User interface aux0 is available.

Press ENTER to get started.

Press Enter at the prompt, and you can configure the switch when the prompt <HP> appears.

NOTE:

For more information about the configuration commands and command line interface, see the

HP 360

v2 Switch Series Configuration Guides

and the

HP 3600 v2 Switch Series Command References

HP 3600 v2 Series - Page 34