HP 410

printing guide
set up printing
5
uninstall and reinstall software
Caution! This is the only way to completely remove the HP Digital
Copier Printer software from your computer. Using any other
method may fail.
The following steps uninstall then reinstall the HP Digital Copier Printer software
on your computer:
1 Disconnect the USB cable from your HP Digital Copier Printer.
Caution! You must complete this step first. If you do not disconnect
the copier/printer from your computer, the software will not
uninstall completely. You will need to follow this procedure again
after disconnecting the printer.
2 Close all virus protection programs and other software running on your
computer.
3 Insert the CD that came with your copier/printer into your computer’s
CD-ROM drive.
Note: If you have misplaced the CD that came with your copier/printer, you
can download the software from the Internet at:
http://www.hp.com/support
4 From the Windows Start menu, select Run, and then click Browse.
5 Navigate to your CD-ROM drive, then locate and double-click the file
labeled uninstall_dc410.bat.
6 When the uninstall feature finishes, restart your computer.
Tip: This step takes several minutes to complete, even though your
system may look like it is idle and the cursor is ready. The uninstall
process occurs in the background after restart. Do not interrupt the
process or reconnect the HP Digital Copier Printer for a minimum
of five minutes.
7 After a minimum of five minutes, reconnect your HP Digital Copier Printer to
your computer with the USB cable.
The New Hardware Wizard appears.
8 Reinstall the software according to the instructions for your operating
system in install on Windows 98, 98SE, Me, or 2000 on page 2, or install
on Windows XP on page 3.
open the printer properties dialog box
There are three main ways to open the Printer Properties dialog box. You can
open it from the Windows Start menu, the system tray, or within an application.
to open the dialog box from the Windows Start menu:
1 Choose one of the following methods:
– From the Windows Start menu, select Settings, Printers.
– For Windows XP, navigate from the Start menu to Printers and Faxes.
2 Right-click hp digital copier 410, and select Properties; or, for Windows XP,
select Printing Preferences.