HP 425 Datasheet

Product overview
The HP 425 802.11n Dual Radio Access Point Series, designed to work in sync with HP
controllers, delivers high-performance networking solutions. The enhanced controller
architecture scales to IEEE 802.11n—without requiring a controller replacement. The
controllers provide advanced radio resource management (RRM), including client load balancing
and interference mitigation. And the wireless controllers support a fast-roaming capability—an
important feature, especially for VoIP communications.
The 425 Access Points work in a managed mode with HP wireless LAN controllers. The access
points (APs) provide RF spectrum analysis with detection and classication of non-IEEE 802.11
interference; and they have the ability to automatically resist interference. Wireless security
is comprehensive with integrated wireless IDS (Intrusion Detection System) and support for
internal and external authentication, authorization, and accounting (AAA) servers; built-in
stateful rewalls; per-user VLAN mapping; and authentication.. In addition to working with HP
MSM controllers, the APs work with the new HP 10500/7500 20G Unied Wired-WLAN Module,
the HP 800 Series Unied Wired-WLAN Switch, and the HP WX5002/5004 wireless controllers.
A summary of the highlights of the 425 Access Points:
• Dual radio—two spatial stream access supporting 300 Mb/s per radio
• Support for embedded antennas as well as an optional external antenna
• Powered via the IEEE 802.3af power over Ethernet (PoE) or the local power supply
• Comprehensive WLAN security
• Lifetime Warranty 2.0—which comes with 24x7 telephone support for three years
Data sheet
HP 425 802.11n Dual Radio
Access Point Series

HP 425 Specifications

General

Device Type	Wireless Access Point
Product Name	HP 425
Maximum Data Rate	300 Mbps
Ethernet Ports	1
Wireless Protocol	802.11n
Frequency Band	2.4 GHz
Antennas	2 internal antennas
Power Source	Power over Ethernet (PoE) or External Power Adapter
Security Features	WPA, WPA2, WEP, 802.1X