WARNING! To reduce potential safety issues, use only the user-replaceable battery provided with the
computer, a replacement battery provided by HP, or a compatible battery purchased from HP.
IMPORTANT: Removing a battery that is the sole power source for the computer can cause loss of
information. To prevent loss of information, save your work or shut down the computer through Windows
before you remove the battery.
Remove the battery:
1. Remove the four Phillips M2.0 × 4.0 screws (1) that secure the battery to the computer.
2. Lift the bottom of the battery and remove it from the computer (2).
To install the battery, reverse the removal procedures.
Memory modules
To remove the memory modules, use this procedure and illustration.
Table 5-3
Memory module descriptions and part numbers
Description Spare part number
16 GB L67710-005
8 GB L46598-005
4 GB L83673-005
Before removing the memory, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 30).
2. Remove the bottom cover (see Bottom cover and rubber feet on page 30).
3. Remove the battery (see Battery on page 32).
If you are replacing a memory module, remove the existing memory module:
Memory modules
33
To Next Page
Loading...
