● Fingerprint reader cable (ZIF) (9) (select products only)
● USB board cable (ZIF) (10)
2. Remove the three Phillips M2.0 × 4.0 screws (1) and the three Phillips M2.0 × 2.5 screws (2) that secure
the system board to the computer.
3. Lift the side of the system board upward (3), and then pull the system board away from the connectors
on the side of the computer to remove it (4).
To install the system board, reverse this procedure.
Speakers
To remove the speakers, use this procedure and illustration.
48
Chapter 5Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
