HP 470 17 inch G9 Notebook PC - Page 44

Before removing the hard drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 30).
2. Remove the bottom cover (see Bottom cover and rubber feet on page 30).
3. Remove the battery (see Battery on page 32).
Remove the hard drive:
1. Lift the hard drive assembly out of the computer (1).
2. Disconnect the hard drive cable from the ZIF connector on the system board (2).
3. Pull the connector o the back of the drive (1).
4. Flex the edges of the cover o the drive to remove the cover (2).
38 Chapter 5Removal and replacement procedures for authorized service provider parts