3. Lift the front edge of the cover (2), swing it toward you, and remove the cover. The memory/WLAN
module compartment cover is included in the Plastics/Hardware Kit, spare part number
448431-001.
4. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The edge of the module opposite the slot rises away from the computer.)
5. Remove the memory module (2) by pulling the module away from the slot at an angle.
NOTE: Memory modules are designed with a notch (3) to prevent incorrect installation into the
memory module slot.
Reverse this procedure to install a memory module.
36 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
