Model 5328A
Programming
Table
5-2.
Program Code Set
!
NOTE
~
Codes shown in
bold face
are start-up conditons. These conditions are set by the code
"P",
Remote Program Initialize, or by the bus commands Device Clear or Selected Device Clear.
1.
Initialization Code
P Remote Program Initialize
2. Function Codes
Stop
Start A
Start Clock
DVM/A
Freq. A
DVMfl.1. A--B
Period
A
Period Avg A
T.I. A--B
N.B/A
T.I. Avg A--B
Events C, T.I. A-B
Check
N .C/A
Freq. C
DVM
tFunctions not labeled on instrument front panel (see Figure 3-8)
3. Time Base Codes
Code Freq Res Multiplier Time Res (Std) Time Res (Opt. 040)
1
MHz
100 kHz
10 kHz
1 kHz
100 Hz
10 Hz
1
Hz
0.1 Hz
4.
Single-Multiple Measurement
SB Single Measurement
S1 Multiple Measurement
5. Measurement Cycle
S2 Wait to output; Service Request at end of measurement
S3 Continue cycle; no Service Request
6. Output Mode
S4 Output at end of measurement
S5 Output when addressed (on-the-fly)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
