HP 560

The HP 560 is a Wi-Fi Alliance authorized Wi-Fi CERTIFIED
802.11ac product. The Wi-Fi CERTIFIED Logo is a certification
mark of the Wi-Fi Alliance.
HP 560 802.11ac Access Point Quickstart
This Quickstart shows you how to install and get started using the HP 560 Dual Radio 802.11ac Access Point [J9846A (WW), J9845A (AM), J9847A (JP),
J9848A (IL)], hereafter referred to as the AP. The latest HP documentation is available at www.hp.com/support/manuals.
Important: To work with this AP, controllers require a minimum software version. For details, see the latest release notes for Unified or MSM software.
Hardware overview
➀
➁
➂
Front view
1: Status LEDs (left to right) Power/System OK, Ethernet, Radio 1, Radio 2
2: Cable lock hole
3: Retention screw hole
➀
➀
➀
➀
➁
➂
➃
➄
Back view
1: AP Bracket tab slot
2: Ethernet port
3: Console port
4: Cable channel
5: Reset button

HP 560 Specifications

General

Model	HP 560
Wireless Standards	IEEE 802.11a/b/g/n/ac
Frequency Band	2.4 GHz, 5 GHz
Power over Ethernet (PoE)	Yes
Antennas	Internal
Operating Temperature	0°C to 40°C

Summary

Hardware Overview

Front View Components

Identifies and describes the LEDs, cable lock hole, and retention screw hole on the front of the AP.

Back View Components

Identifies and describes the bracket slot, Ethernet port, console port, cable channel, and reset button on the back of the AP.

Initial Setup and Safety

Package Contents, Ports, and Radios

Lists included items, details ports (Ethernet, Console), and describes dual radios and reset function.

Installation Prerequisites and Safety

Covers safety, plenum installation, country selection, and power options for AP deployment.

Access Point Installation

Mounting Methods

Outlines wall, electrical box, and suspended ceiling mounting methods for the AP bracket.

Installation Procedures

Step-by-step guides for mounting the AP bracket on walls, electrical boxes, and ceilings.

Attaching and Securing the AP

Guides on connecting Ethernet, attaching the AP to the bracket, and using retention screws.

AP Operation Modes and Configuration

Removing the AP and Controller Mode

Instructions for removing the AP and operating it in controller-managed mode with LED status.

Autonomous Mode Setup

Guides on configuring the AP in standalone autonomous mode via web interface.

Network Configuration

Steps for configuring wireless protection, assigning IP addresses, and testing the network.