Appendix B: Camera dock 73
Appendix B: Camera
dock
NOTE The HP Camera Dock does not work without AC
power. Be sure to use ONLY the HP AC adapter and the
cables that came with the Camera Dock.
1 Follow the setup instructions provided with the Camera
Dock. This includes installing the Dock Insert onto the dock,
installing rechargeable batteries in the camera, connecting
the AC power source, and connecting the Camera Dock to a
computer, printer, and/or television.
2 Make sure your camera is set up
correctly and remove any cables that
may be attached to it before putting
it in the dock.
3 Place the camera in the Camera
Dock with the rear of the camera
facing the front of the Camera Dock.
The Camera Dock has three I/O connectors on the back:
—Connects to the television
—Connects directly to HP USB
DeskJet and Photosmart printers
—Connects to your computer
There is a sliding door over the
computer and printer connectors that
prevents you from using both connectors at the same time (the
Camera Dock is not a USB hub).
To Next Page
Loading...
Need help?
General
