HP 900 Series - Figure 2-10. Releasing the Front Panel Catches

Front Panel
Preliminary Requirements
1. Turn the unit off.
2. Remove the power cord.
Procedures
1. Using a thin blade flat-tip screwdriver, release the front panel catches on the right and
left sides by pressing them inward as shown in Figure 2-10.
Figure 2-10. Releasing the Front Panel Catches
2. Carefully tilt the front panel forward to a 45° angle.
3. The front panel can be removed and set aside.
Note
When installing the front panel, ensure the lip at the bottom of the
front panel fits over the sheet metal on the bottom of the fan housing.
4. To install the front panel, reverse steps 1 through 4.
Assembly Replacement 43