HP Brio BA - What to Do Next

19
Replacing the Floppy Drive
Replacing the Floppy Disk Drive
Replacing the Floppy Disk Drive
1 Slide the drive into the drive bay, making sure that the connectors on the
rear of the drive are at the back of the bay.
2 Replace the two drive cables.
3 Replace the four screws. Refer to step 3 on page 18 for the location of the
screws.
4 Slide the drive into the computer, making sure that the slots ➊ are located
on the tags ➋.
5 Replace the floppy drive bay fixing screw.
6 Replace the cover.