2. Carefully raise the front of the product.
WARNING! Do not place the product face-up resting on the rear cover and rear door. Excess
toner might enter the laser/scanner assembly and contaminate the mirrors, causing print-quality
problems. The laser/scanner is not a FRU. If the laser/scanner mirrors are contaminated, the entire
product must be replaced.
CAUTION: The ADF and scanner cover are not captive and can open suddenly when the product
is placed front-side face up. Always support the ADF and scanner cover before placing the product
front-side face up.
Do not lift the product grasping the front door and Tray 2 cavity.
Figure 6-9 Remove the pickup roller (1 of 2)
ENWW Paper-feed rollers and pads 129
To Next Page
Loading...