HP Color LaserJet CM2320 - Multifunction Printer - Page 284

Control panel message Event log error message Description Recommended action
Verify the pickup roller and
separation roller are working
correctly. If necessary, replace
the rollers.
If the error persists, replace the
product.
Load Paper <Type> Out of paper in all available trays. If paper is already loaded in the
tray, test the paper sensors.
Verify that all DC controller
connectors are firmly connected.
Load Tray 1 <TYPE> <SIZE>,
Press OK to use available
media
The product is processing a job,
but no trays match.
Load paper in the correct
orientation.
Press OK to use existing tray
settings.
Load Tray 1, <PLAIN> <SIZE> /
Cleaning mode, OK to start
This is the product cleaning mode
paper prompt.
Load a clean sheet of paper in the
correct orientation, then press
OK to begin the cleaning
procedures.
Load Tray X <TYPE> <SIZE>,
Press OK to use available
media
The product is processing a job,
but a matching tray is empty.
Press OK to use existing
available media.
Manual Duplex Load Tray 1,
Press OK
The product is set to the manual
duplex mode.
Load paper in the correct
orientation.
Manual feed <SIZE> <TYPE>,
Press OK to use available
media
The product is in manual feed
mode.
Load paper into the indicated
tray.
Memory is low Try again later The product does not have
enough memory to start a new
job.
Turn the product off and then on
to clear the memory.
If the error persists, perform an
NVRAM initialization.
If the error persists, update the
firmware.
Memory is low. Press OK The product memory has been
almost completely filled.
Press Cancel
to clear the
error.
Break the job into smaller jobs
that contain fewer pages.
Turn the product off and then on
to clear the memory.
Memory low Only 1 copy made.
Press OK to continue.
The product does not have
enough memory to complete the
collated copy job.
Break the job into smaller jobs
that contain fewer pages.
Turn the product off and then on
to clear the memory.
Misprint, Press OK Feed delay misprint. Verify that paper is loaded in the
input tray.
Reload the paper.
Table 7-12 Control-panel messages (continued)
272 Chapter 7 Problem solve ENWW