Hardware Reference Guide www.hp.com 2–5
Hardware Upgrades
Replacing the Computer Cover
To replace the computer cover:
1. Hold the cover over the chassis, then rest the guide tabs located
inside the cover on the diagonal ramps at the rear of the chassis.
2. Slide the cover along the ramps and into place on the chassis 1.
3. Tighten the two captive thumbscrews 2.
Replacing the Computer Cover
4. If you normally lock the Smart Cover Lock, use Computer Setup
to relock the lock and enable the Smart Cover Sensor. For more
information about Computer Setup, refer to the Computer Setup
(F10) Utility Guide on the Documentation Library CD.
To Next Page
Loading...
