HP Compaq dc5700 MT User Manual

6–14 437804-001 Service Reference Guide, dc5700
Removal and Replacement Procedures— Microtower (MT) Chassis
7. If replacing or adding a new expansion card, hold the card just above the expansion slot on
the system board then move the card toward the rear of the chassis 1 so that the bracket on
the card is aligned with the open slot on the rear of the chassis. Press the card straight down
into the expansion slot on the system board 2.
✎
When installing an expansion card, press firmly on the card so that the whole connector seats
properly in the expansion card slot.
8. If you are replacing an expansion card, store the old card in the anti-static packaging that
contained the new card.
9. While holding the expansion card bracket against the chassis, slide the slot cover lock down
toward the expansion card brackets and slot covers 1 to secure them in place and replace the
thumbscrew 2 that secures the slot cover lock.
10. Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.

HP Compaq dc5700 MT Specifications

General

Chipset	Intel Q965 Express
Audio	Integrated High Definition audio
Network	Integrated Broadcom NetXtreme Gigabit Ethernet
Power Supply	300W
Form Factor	Microtower
Processor	Intel Pentium D, Intel Celeron D
Memory	Up to 4 GB DDR2
Graphics	Intel Graphics Media Accelerator 3000
Optical Drive	DVD-ROM
Expansion Slots	1 PCI Express x16
Ports	USB 2.0, VGA, serial, parallel
Operating System	Windows XP Professional, Windows Vista
Storage	SATA Hard Drive