Hardware Setup
Step 7: Turn On the Notebook
To turn on the notebook:
ยป Press the power/standby button 1.
The power/standby light next to the power/standby button 1
and the power/standby light on the front of the notebook 2
are turned on, and you are prompted to begin software
setup.
If the notebook does not power up:
โ ๎ฟ Make sure the AC adapter is securely plugged into the
notebook and an electrical outlet.
โ ๎ฟ Make sure the electrical outlet is providing power. (To
confirm that the outlet is providing power, plug another
device into the outlet.)
โ ๎ฟ If you have installed a battery pack, make sure the
battery pack is firmly seated.
โ ๎ฟ Refer to the Worldwide Telephone Numbers booklet (English
only) included with the notebook to contact Customer Care.
1โ12๎ฟ Getting Started
To Next Page
Loading...
