2-4 Hardware Upgrades
Compaq Confidential - Need to Know Required
Writer: Beth Zanca Part Number: 190709-001 File Name: ch2.doc
Last Saved On: 04/12/00 1:02 PM Last Saved By: Lydia Sanchez
Removing the Front Bezel
To remove the front bezel:
1. Turn off the workstation and any external devices.
2. Disconnect the power cord from the grounded AC outlet and the
back of the workstation.
3. Remove the workstation access panel. Refer to the instructions in
Removing the Workstation Access Panel in this chapter.
4. Push in on the two front bezel release tabs, then rotate the front
bezel away from the chassis to release it.
Pressing the front bezel release latches to remove the front bezel
✎
When replacing the front bezel, ensure that the bottom hinge
points are properly placed in the chassis before rotating the
front bezel back into its original position.
To Next Page
Loading...
Need help?
General