1-28
D Class System Memory Upgrade
Memory Upgrade Verification Procedure
E. Verify Memory Installation If successful, the following steps complete
the memory installation verification. If the memory verification is not successful,
refer to the section titled Troubleshooting Memory Configuration Error
Symptoms at the end of this manual.
1. At the Main menu, type “in me” to get to display memory information.
2. Confirm that the amount of memory listed in the memory information display is
equal to the amount of memory you have installed in the system.
Example Display
for Models D200/
D210/D310
-------
Main Menu: Enter command > in me
MEMORY INFORMATION
Slot Card Size Amount Enabled
---- --------- --------------
0 16 MB 16 MB
1 16 MB 16 MB
2 16 MB 16 MB
3 16 MB 16 MB
Physical Memory: 64 MB (0x04000000)
Configured Memory: 64 MB (0x04000000)
Main Menu: Enter command >
To Next Page
Loading...
Need help?
General