2-16
R Class System Memory Upgrade
Memory Installation Procedure
I. Replace the
Processor/ Memory
Card
1. Verify that an anti-static strap is still strapped to your wrist, and grounded to the
cabinet main chassis.
2. Place the Processor/Memory card into the system cabinet so that the card rests in
the metal rails with the large connector facing into the cabinet (see the figure on
page 2-9).
3. Pull the extractor levers on the Processor/Memory card out away from the card.
4. Slide the Processor/Memory card into the system cabinet until the large
connector is properly seated in the corresponding system board connector.
5. Push in the two extractor levers on the Processor/Memory card.
6. Insert and tighten two screws to secure the Processor/Memory card in the
cabinet.
7. Reattach power cables P13 and P14.
To Next Page
Loading...
Need help?
General