39
Setting the Drive Mode
Your camera features a Self-timer and Burst which can be
set in the Drive mode function in the Record Menu. The
Self-timer allows you to take images after a pre-defined
delay. While burst lets you take consecutive shots. This
function is only available in recording still images. The
Drive mode setting is automatically set to off when you
turn off the camera.
To set the Drive Mode
1. From the Record menu, select Drive Mode.
2. Use the or keys to go through the selection.
3. Press the OK button to save and apply changes.
The table below shows the available Drive mode settings.
Icon Item Description
Off Captures an image without time delay.
10 Sec.
Sets a 10-second delay to capture image after pressing the Shutter
button.
2 Sec.
Sets a 2-second delay to capture image after pressing the Shutter
button.
Double
Performs delay and capture twice:
• Performs a 10-second delay, then captures the image.
• Performs another 2-second delay then captures the image again.
Setting the AF Area
AF stands for Automatic Focus. This feature determines
the area on which the camera focuses.
To set AF Area
1. From the Record menu, select AF Area.
2. Use the
or keys to go through the selection.
3. Press the OK button to save and apply changes.
The table below shows the available AF area settings.
Icon Item Description
Wide The camera automatically selects focus area within the wide frame.
Center The focus area is fixed on the center.
Setting the AF Lamp
To Next Page
Loading...
Need help?
General
