Assigning a name to a Java Card
You must assign a name to a Java Card before it can be used for power-on authentication.
To assign a name to a Java Card:
1. Select Start > All Programs > HP ProtectTools Security Manager.
2. In the left pane, click Java Card Security, and then click Advanced.
3. Insert the Java Card into the card reader.
NOTE: If you have not assigned a PIN to this card, the New Card dialog box opens, allowing you
to type a new name and PIN.
4. In the right pane, under Display name, click Change.
5. Type a name for the Java Card in the Name box.
6. Type the current Java Card PIN in the PIN box.
7. Click OK.
Setting power-on authentication
When enabled, power-on authentication requires you to use a Java Card to start the computer.
The process of enabling Java Card power-on authentication involves the following steps:
1. Enable Java Card power-on authentication support in BIOS Configuration or Computer Setup. For
more information, see “
Enabling and disabling smart card power-on authentication support
on page 46.”
2. Enable Java Card power-on authentication in Java Card Security.
3. Create and enable the administrator Java Card.
ENWW Advanced tasks (administrators only) 39
To Next Page
Loading...
