HP DesignJet T730

●
Touch to view ink information.
●
Touch to view information about printheads.
●
Touch to view connectivity status information and to perform network conguration. If a network
cable is connected, is displayed instead.
NOTE: It is not possible to use wireless and wired network connections simultaneously.
●
Touch to view information about wi- direct.
●
Touch to view information and congure ePrint to print from a computer or mobile device sending an
email to the printer.
If the printer is left idle for some time, it goes into sleep mode and switches o the front-panel display. To
change the time that elapses before sleep mode, Touch , then Printer setup > Sleep Mode. You can set a
time between 5 minutes and 3 hours.
The printer wakes from sleep mode and switches on the front-panel display whenever there is some external
interaction with it.
Information about specic uses of the front panel can be found throughout this guide.
Printer software
The following software is provided with your printer:
●
The HP-GL/2 and HP RTL driver for Windows
●
The Embedded Web Server allows you to:
◦
Manage the printer from a remote computer
◦
View the status of the ink cartridges, the printhead, and the paper
◦
Access the HP Support Center, see HP Support Center on page 194
◦
Update the printer's rmware, see Firmware update on page 109
◦
Perform alignments and troubleshooting
◦
Change various printer settings
◦
Manage email notications
See Access the Embedded Web Server on page 28.
●
The HP Utility allows you to:
◦
Manage the printer from a remote computer
◦
View the status of the ink cartridges, the printhead, and the paper
◦
Access the HP Support Center, see HP Support Center on page 194
◦
Update the printer's rmware, see Firmware update on page 109
◦
Launch the Embedded Web Server
See Access the HP Utility on page 28.
ENWW Printer software 11