NOTE: The printer only accepts rolls with 2–inch cores. For further details on roll specications, see
Table 24-2 Paper specications on page 198.
If you are a regular user of dierent paper types, you can change rolls more quickly if you preload rolls of
dierent paper types on dierent spindles. Extra spindles are available for purchase, see Accessories
on page 115.
Load a roll into the printer
To start this procedure, you must have a roll loaded on the spindle. See Load a roll onto the spindle
on page 34.
1. From the front panel, select the paper tab, touch , then touch Load roll and follow the front panel
instructions.
This step is optional: if you just start feeding in roll paper, the printer recognizes that you want to load a
roll.
2. Make sure the cover is open.
3. Insert the spindle into the printer, holding it by both ends. The blue hub should be on the left, as viewed
from the front of the printer.
4. If the edge of the roll is not straight or torn (sometimes due to tape used to hold end of the roll), pull the
paper slightly and cut a straight edge.
ENWW Load a roll into the printer 37
To Next Page
Loading...
