HP Designjet Z5200 - PostScript Printer Using

1. Remove the right-hand end of the spindle from the printer, then the other end.
WARNING! Do not insert your fingers into the spindle supports during the removal process.
2. The spindle has a stop at each end to keep the roll in position. The blue stop can be removed to
mount a new roll; it slides along the spindle to hold rolls of different widths. Remove the blue
paper stop from the end of the spindle.
3. If your roll has a 76 mm (3 in) cardboard core, ensure that the core adaptors have been
installed.
4. If the roll is long, rest the spindle horizontally on a table and load the roll on the table.
26 Chapter 4 Paper handling ENWW
Paper handling

HP Designjet Z5200 - PostScript Printer Specifications

General

Print Technology	Thermal Inkjet
Number of Inks	8
Memory	32 GB (virtual)
Hard Disk	160 GB
Line Accuracy	+/- 0.1%
Maximum Print Resolution	2400 x 1200 dpi
Ink Colors	Cyan, Magenta, Yellow, Light Cyan, Light Magenta, Light Gray
Media Sizes Supported	Up to 44 inches wide
Connectivity	Gigabit Ethernet (1000Base-T), Hi-Speed USB 2.0
Minimum Line Width	0.02 mm
Maximum Optical Density (Black)	2.5
Media Types	Bond and coated paper, photographic paper, self-adhesive and banner
Media Sizes Standard (Sheets)	A4, A3, A2, A1, A0
Media Sizes Standard (Rolls)	24 to 44-in rolls
Media Thickness	Up to 0.8 mm
Connectivity, Standard	Gigabit Ethernet (1000Base-T); Hi-Speed USB 2.0 certified; EIO Jetdirect accessory slot
Print Languages	Adobe PostScript 3, Adobe PDF 1.7, TIFF, JPEG, HP-GL/2, HP-RTL, CALS G4
Ink Types	Pigment-based
Operating Temperature Range	5 to 40°C
Dimensions (W x D x H)	1770 x 721 x 1050 mm