To Next Page

To Previous Page

TIP: You may need two people to handle a large roll.

5. Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not,

remove the roll, turn it 180 degrees and slide it back on to the spindle. There are labels on the

spindle showing the correct orientation.

NOTE: From the back of the printer, the blue stop is fitted onto the right-hand end of the

spindle.

Ensure both ends of the roll are as close to the spindle stops as possible.

6. Put the blue paper stop onto the open end of the spindle, and push it towards the end of the roll.

7. Ensure the blue paper stop is pushed in as far as it goes, until both ends are against the stops.

If you are a regular user of different paper types, you can change rolls more quickly if you preload

rolls of different paper types on different spindles. Extra spindles are available for purchase, see

Accessories on page 123.

Load a roll into the printer

There are two ways to load a roll. The easy loading procedure is recommended.

To start these procedures you must have a roll loaded on the spindle. See

Load a roll onto the

spindle on page 25.

ENWW Load a roll into the printer 27

Paper handling

Other manuals for HP Designjet Z5200 - PostScript Printer

Questions and Answers:

Need help?

Do you have a question about the HP Designjet Z5200 - PostScript Printer and is the answer not in the manual?

General

Print Technology	Thermal Inkjet
Number of Inks	8
Memory	32 GB (virtual)
Hard Disk	160 GB
Line Accuracy	+/- 0.1%
Maximum Print Resolution	2400 x 1200 dpi
Ink Colors	Cyan, Magenta, Yellow, Light Cyan, Light Magenta, Light Gray
Media Sizes Supported	Up to 44 inches wide
Connectivity	Gigabit Ethernet (1000Base-T), Hi-Speed USB 2.0
Minimum Line Width	0.02 mm
Maximum Optical Density (Black)	2.5
Media Types	Bond and coated paper, photographic paper, self-adhesive and banner
Media Sizes Standard (Sheets)	A4, A3, A2, A1, A0
Media Sizes Standard (Rolls)	24 to 44-in rolls
Media Thickness	Up to 0.8 mm
Connectivity, Standard	Gigabit Ethernet (1000Base-T); Hi-Speed USB 2.0 certified; EIO Jetdirect accessory slot
Print Languages	Adobe PostScript 3, Adobe PDF 1.7, TIFF, JPEG, HP-GL/2, HP-RTL, CALS G4
Ink Types	Pigment-based
Operating Temperature Range	5 to 40°C
Dimensions (W x D x H)	1770 x 721 x 1050 mm