22.2:YZ
Cause
Solution
ISS Right BPS0 error.(Supplies 0, 1, 2)(Module 2 far right). Try the following:
●
Switch the Power OFF from the back of the Printer and
disconnect the Power cord. Reconnect the power cord
and power On the Printer.
●
Check that the cables between the Right Ink Supply
Station and PrintMech PCA the are not damaged and are
correctly connected.
●
Perform the Ink Delivery System diagnostic test to
troubleshoot the problem further
7. Ink Delivery
System (IDS) on page 106.
●
If the System Error continues, replace the Right Ink
Supply Station
refer Right Ink Supply Station
on page 280.
●
If the System Error continues, replace the Main PCA
refer Electronics Module (Main PCA and PSU)
on page 298.
24:YZ
Cause
Solution
Ink Setup failure ( Ink Delivery System (IDS) Tubes purge
failed).
Try the following:
●
Switch the Power OFF from the back of the Printer and
disconnect the Power cord. Reconnect the power cord
and power On the Printer.
●
Check that the cables between the Right Ink Supply
Station and PrintMech PCA the are not damaged and are
correctly connected.
●
Try purging the Ink Supply Tubes again once the Printer
has been restarted.
●
Install new Cartridges in the printer and try purging the
Ink Supply Tubes again.
26.n:YZ (color = n)
Cause
Solution
Order of Ink Supplies incorrect. Try the following:
●
Remove the Ink Supply Cartridges and check that they
are the correct ones for this printer and are in the proper
order.
●
Check that the Printer has the latest firmware. If not,
update the firmware to the latest version.
56 Chapter 2 System Error Codes ENWW
To Next Page
Loading...
