22.0:YZ
Cause
Solution
ISS Left BPS0 error.(Supplies 0, 1, 2) (Module 0 left). Try the following:
●
Switch the Power OFF from the back of the Printer and
disconnect the Power cord. Reconnect the power cord
and power On the Printer.
●
Check that the cables between the Left Ink Supply Station
and Main PCA the are not damaged and are correctly
connected.
●
Perform the Ink Delivery System diagnostic test to
troubleshoot the problem further
7. Ink Delivery
System (IDS) on page 106.
●
If the System Error continues, replace the Left Ink Supply
Station
refer Left Ink Supply Station on page 284.
●
If the System Error continues, replace the Main PCA
refer Electronics Module (Main PCA and PSU)
on page 298.
22.1:YZ
Cause
Solution
ISS Left BPS1 error.(Supplies 3, 4, 5)(Module1 middle right). Try the following:
●
Switch the Power OFF from the back of the Printer and
disconnect the Power cord. Reconnect the power cord
and power On the Printer.
●
Check that the cables between the Left Ink Supply Station
and PrintMech PCA the are not damaged and are
correctly connected.
●
Perform the Ink Delivery System diagnostic test to
troubleshoot the problem further
7. Ink Delivery
System (IDS) on page 106.
●
If the System Error continues, replace the Right Ink
Supply Station
refer Right Ink Supply Station
on page 280
●
If the System Error continues, replace the PrintMech PCA
refer PrintMech PCA on page 220.
ENWW System Error Codes - Full Descriptions 55
To Next Page
Loading...
